Einhausen plant with the JRT Elastomer Tec signEINHAUSEN PLANT, SINCE 1982
Moulded hose being wrapped on the mandrel

From the founding to today

1982

Founded in Einhausen

Friedrich Jung founds the company in Einhausen. It starts with hand-fabricated hoses, bends and moulded parts.

We develop and manufacture technical elastomer parts in our own plant. That way we follow every part through every phase up to the finished product.

Quality and testing

Production in four steps

Rubber compound granulate in the hand
01 MATERIAL & COMPOUND

The compound is selected to suit the application and its operating conditions. Before processing it goes through the defined incoming inspection.

Press tool with two mould cavities
02 PRODUCTION PLANNING

Part, production method and the necessary tooling are matched to each other. Moulds and tools are made together with qualified partners.

Employee fabricating a moulded hose
03 PRODUCTION METHOD

Depending on application, geometry and quantity, we use pressing, extrusion, hand fabrication and multi-layer construction of hoses and moulded hoses. Special parts are made individually to your requirements.

Employee inspecting a hose
04 INSPECTION & MARKING

The parts are inspected against the defined quality requirements and marked individually where needed. Additional tests and test documentation depend on the product and customer requirements.

Assemblies, marking, shipping

On request we assemble individual parts into assemblies. We mark parts by colour or permanently by embossing. We pack in cartons, on pallets or to your specification and ship by parcel service, air freight or sea freight.

Advice on product and application

It starts with advice on the future product and its intended use. Based on your drawing or specification, we also advise on how the part can be optimised.

Same people, new name.

Write to us as usual, now at [email protected].

[email protected]